A blog of all sections with no images
Soap Film On Stone
SOAPFILM
Type:
Soap film on shower walls and vanity tops.

Problem:
Soap from showers can build up on shower walls leaving a film that will not wash off with regular cleaning.

Solution:
1.If soap film is thick,scrap with a razor blade.Wet the surface to avoid scratching the surface.
2.Once all heavy build-up is removed clean with acetone and a green scrub pad.
3. There are also commercial soap film removers on the market which work well, but be careful that they do not contain acids which can etch polished marble.
Several poultices may need to be applied to completely remove all staining.
 
Beer Stain
BEER

Types:
There are literally hundreds of types of beers. The beer that seems to be more of a problem with staining are the dark beers. Countertops are very susceptible to dark beer staining.

Problem:
The sugars and proteins in the beer can cause a very dark stain on light colored stones.

Solution:
1.Clean the entire area thoroughly with water and a mild detergent( Dishwashing soap like ivory works well).Allow the water and soap to soak into the stone for several minutes.Lightly agitate the area and remove excess water with a dry towel.Rinse the area with clear water.

2.If the above cleaning procedure does not remove the beer stain, then try a stronger cleaner such as ammonia and water.

3.If the stone is still stained, prepare a powder poultice with 30-50 % Hydrogen peroxide.
Several poultices may need to be applied.
 
Adhesive Stain
Adhesive Stain
Types:
Tape residue, cellophane, band-aids, stickers, etc.


Problem:
Sticky residue on surface of stone.Some tape residues especially duct tape, can penetrate below the surface of the stone and can be very difficult to remove.


Solution:
1. Peel off any remaining tape, use a very sharp razor blade and be careful not to scratch the surface of the stone.

2. The remaining sticky residue can usually be removed with a rag and acetone.Pour the acetone on a clean white rag and rub the area until all the sticky residue is gone.

3. If the adhesive has left a stain, then prepare a poultice of Diatomaceous earth or similar powder with one of the following
solvents:

*Mineral spirits

*Toluene

*Xylene

*Methylene chloride
 
Seems in Granite

Using De-Lipage, a process wherby grinding action eliminates uneven seams from a poorly executed installation, the natural glory of these surfaces is realized. These images show the phases of the process.
 
Scratch Removal From Stone

Through the course of time your stone will be scratched and become dull. The images to the left display the scratches.The images to the right are the stone after it has been resurfaced and treated. Most people mistake scratched surfaces for dirty surfaces.
 
Hone

These images are all hone finished. Hone is the absence of a reflection. This finish is best used on floors and high traffic areas. This finish leaves the pores of the stone open. It must be sealed with the proper impregnator.
 
More...
<< Start < Prev 1 2 3 Next > End >>

Results 21 - 30 of 30
[ Back ]